QuickCell
A test system for all types of assembly lines
At 500 test pieces per minute, QuickCell guarantees the industrial user a complete, self-sufficient working test system which can be integrated seamlessly into all assembly lines - all this at a reasonable price. This new kind of leak test system consists of a multi-channel device. It is in the position, during continuous cycling, to perform a leak test using pressure increase measurements in a pre-evacuated secondary volume, to analyze results and transmit the test result (leak value) to an exterior visualization station.
It is also possible to test using over-pressure and then measure pressure reduction.
The measurement procedure is determined by the corresponding station setup.
The pressure increase measurement procedure
The pressure increase measurement procedure
The normally sealed and closed test pieces e.g. products, are placed into one of 20 sealed closed chambers (= secondary volume) with a pre-set under-pressure. The pressure increase in the secondary volume (due to leaks from the interior of the test piece) is acquired and analyzed by a pressure sensor. The leakage is then obtained from:
q leak = V x dp / dt [mbar*L/sec]. The large leak detection results from the achieved test pressure.
The advantages at a glance are:
The advantages at a glance are:
- High performance: even for 500 parts/min, through continuous test technology
- Leak test with pressure increase or decrease on open or sealed parts
- Large leak test enclosed
- Test flexibility mechanical tests and optical controls are integratable
- Especially suited for concentric or oval plastics or panel parts
- Gentle parts handling with specially developed transfer and receiving technologies
- Integration capable into assembly with cycled automation
- Implementable in many sectors: Plastics, connections, packaging, foodstuffs, cosmetics, medical technology
Technical data
Technical data
| Smallest detectable leak rate | 10E-4 mbar*L/sec |
| Practically useful measurement range | 10E-4 to 10E-1 mbar*L/sec and large leak |
| Test type | pressure increase or decrease measurement including large leak detection |
| Computer | industrial PC |
| Windows operating system | |
| Software | LEO process module leak test |
| Interfaces | PROFI / Ethernet /RS232 / ind.IO |
| Electrical energy | 230 VAC / 50 or 60 Hz |
| Pneumatic energy | min. 5 bar |